I was told this after contacting several Dodge dealerships in the Wash, DC area. Thanks in advance for any help you can offer. CarComplaints.com: Car complaints, car problems and defect information Latest News Nov 10: Audi 'Defeat Device' Lawsuit Targets 3-Liter Gasoline Vehicles Nov 6: New Audi Defeat Device Found? When you installed the redesigned resistor, did it just plug right in, even though it has one less pin? Check This Out
His information helped me tremendously! Close RepairPal Get Your Car Fixed Learn About Your Car About RepairPal For Shop Owners RegisterSign Install the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and the lower HVAC housing. the old solid fins.
the old solid fins. Has anyone replaced their own resister? the old solid fins.
Remove the recirculation door actuator. Any help will be much appreciated![emailprotected] g Judged: 9 Reply » Report Abuse Judge it! Helpful websites Chrysler Minivan Fan Site - Information about problems and recalls. 2003 Dodge Caravan Blower Motor Resistor Donna Union Grove, WI #150 Feb 4, 2009 David wrote: 2002 Chrysler T&C blower motor would only operate on hi-speed setting...unless turned "off" and then it would increase in speed a
Note, the dealer originally told me $114...I balked and he sold it to me for $85. 2006 Dodge Caravan Blower Motor Resistor For body style (2002-2007?) the blower motor resistor can be found behind the glove box. I checked the fuses and relays, they appea...2 answersMay 31, 2010My wifes Grand Caravan is not blowing cold air in front but back ac works fine.Is this a blower motor ,or http://forum.chryslerminivan.net/showthread.php/6704-2005-Dodge-Caravan-Blower-Problem I purchased a blower resistor from the dealer (Part # 04885482AC) and it cost me $104 with $48 cabin filter.
When it does it takes forever to hit. 10 amp fuse for ignition switch keeps breaking, what is causing this ?Why does my transmission shift so hard when i hit about 2003 Dodge Caravan Blower Motor Not Working Anything else you can think of? Route the blower motor wire lead through the opening in the lower air inlet housing and seat the rubber grommet. I think the cabin filter cause the resistor to burn out if you don't replace it regular.
There is continuity between 3 and A, and 6 and B. 1 2 3 | A 4 5 6 | B How do I use the multi meter to check if My Chrysler dealer here on Kauai Hawaii says it is the control arms. 2004 Dodge Caravan Blower Motor Not Working Doesn't matter whether it's the Dodge Grand Caravan or the Chrysler T&C models; not sure if it works for other Chrysler/Dodge models. 2002 Dodge Caravan Blower Motor Not Working Gently flex the recirculation air door downward to gain access to remove the blower motor from the HVAC housing.NOTE: To aid in installation, note the position of the blower motor mounting
Login|Contact Us Dodge Dodge Repair Questions? http://camtronics.net/blower-motor/2002-grand-prix-blower-motor-not-working.html You will need a 5/16 or 8mm socket to remove the 2 screws holding it in place. I'll never buy a Sebring again! I'm being told there's a $35 adaptor harness that has to be purchased for the van to accept the redesigned resistor. 2005 Dodge Caravan Blower Motor Fuse
It has a fuse built into it and its the first thing the ground side of the blower runs into. Get a Professional Answer Via email, text message, or notification as you wait on our site.Ask follow up questions if you need to. 100% Satisfaction Guarantee Rate the answer you receive. Has anyone done that and where is the best place to buy from? http://camtronics.net/blower-motor/2007-dodge-caravan-blower-motor-not-working.html Reply » Report Abuse Judge it!
To remove, open the GB fully and depress the two tabs (top corners) and the GB should fall away. 2007 Dodge Caravan Blower Motor Resistor They have put on 4 new tires, new tie rod end, PS flush, Trans Flush -- because of possible bearing wear, riveted the strut tops down per TSB, dropped and rehung Install the recirculation door actuator.
The green wire is the ground side of the blower. Hopefully they can do the fix for me. With everything plugged in there should be power on the black wire. 2005 Chrysler Town And Country Blower Motor Resistor Airjer_10-02-2008, 10:58 AMThis is a ground side controlled sytem.
The black wire is the power going to the blower. The red passenger airbag light has stayed on. Lower Air Inlet Housing Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing. http://camtronics.net/blower-motor/2004-dodge-caravan-blower-motor-not-working.html I'd recomend NOT replacing with the fin style as the mechanic thinks it was a flawed design.It takes less than 5 minutes to replace the part and is VERY easy.
Reply » Report Abuse Judge it! Airjer_10-01-2008, 11:48 AMMy bad you have a resistor. Last note, if you test the resister prior to remounting it in the opening make sure the cooling fins are NOT grounding out against something...as the fan will run on high Since I bought it used in April 2006.
One question though, does the resistor normally get hot? Reply » Report Abuse Judge it! The dark blue wire should have power to it all the time with the key in the run position. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.
Note, the dealer originally told me $114...I balked and he sold it to me for $85. If you have Auto Temp Control (ATC) like me, congratulations, you're in the expensive bracket it will run about $85 (vs.$23). The module behind the glovebox seems to be the resistor(black, on the left, held in by two screws with a "5 wire plug" (all black and blue) on the left, and