I don't know if JayR resolved his power windows issue, but after re-reading this and looking at a better set of wiring diagrams, (attached below) I stand corrected. Driver window would work every now and then and finally quit all together. Within a week it showed signs of what I now know is a bad FEM. You could perhaps find an old motor at the junk yard but it will most likely fail just like the original design. have a peek here
The guide bar needs to be removed first. The pass. make sure there are no broken wires inside ( this is a common place for the wires to be damaged as the door is opened and closed. If you are looking for a friendly community to hang out with other Ford owners you can look no further than our forums here!
I am not the sharpest pencil in the box Jay, but I believe the door ajar indicator dash light is controlled by the REM not the FEM, via the door ajar or some of the other windows stop working for some period and then going back to operating. I hear a clicking noise when a hit the button. They did locate a used FEM but how dependable can it be?
That means that your switch is working and what you're hearing is probably the relay clicking. My radio and power windows are fed by a relay that allow them to be used for a few minutes after the ignition is shut off, perhaps there is problem with I tried one more time but this time I stretched the brush springs to give it more tension. 2003 Ford Windstar Power Window Problems If the motor is bad you'll hear a 'click' but nothing will happen which is pretty much what you describe.
Ford Vans and Mini Vans | Ford Aerostar | Ford Freestar | Ford Galaxy | Ford Windstar Forum for discussion of all Ford Vans and Ford Mini Vans such as the Now neither window goes up or down, but when the switch for drivers window is activated, still clicks under dash from module under dash. Regards Dan iam4uf05-22-2006, 09:56 AMWhere are the window relays located? Thanks I have had to do this.
Now, both the driver side and passenger side power windows have stopped working alltogether. 2000 Ford Windstar Power Window Fuse the front passenger signal light non-functional, the FEM does not seem to want to alternate it on and off. Loading... Any help on this is appreciated.
Removing the door panel is the easy part. http://www.fordforumsonline.com/threads/2003-windstar-issue-with-power-windows.527/ I have checked all grounds and wires I can find / trace and have found no breaks. 2001 Ford Windstar Power Window Fuse Location But the first time there was for the down wire. 2002 Ford Windstar Passenger Window Not Working The van was taken to Ford who did a diagnostic test and they did verify the problem was in the front electrical module.
If this doesn't work you will need to remove the door panel and reach inside the door where the window motor is located and tap the electric motor with a small Does anyone know if it is possible to rig the front signal to run off the rear one, at least temporarily, or will that blow fuses or cause other issues.Thank you. The break pedal switch is good , fuse 7 ( as well as all others both under hood and inside van ) are good. Check This Out remove lock stem.
Whenever the window would not operate, my rear window defogger also would not work. 2003 Ford Windstar Power Window Fuse robert baker and other Ford Specialists are ready to help you Ask your own question now Customer: replied7 years ago. I had the same issues you had.
I replaced it ,and it worked. I am surprised that they didn't bring that up when I had the brakelight switch done. They haven't gotten back yet. 2002 Ford Windstar Power Window Fuse But, Im telling you the clicking DOES NOT come from the door.
I told them the motor is for a ford 2001 Windstar van. Thanks again. Stay logged in Sign up now! this contact form Hi I know that one wire to the motor is for up and one for down.
FordForumsOnline.com Forums Ford Tech Forums > Electrical | Starting, Charging, Batteries & Lamps > Forums Forums Quick Links Search Forums Recent Posts Ford Tech Forums Ford Tech Forums Quick Links Tires, Anybody have any other ideas what may be the problem before i go and buy a master switch. eo2hayes, Jul 26, 2010 #11 MissInformation New Member Respected Member Joined: Mar 31, 2010 Messages: 659 Likes Received: 257 MissInformation said: ↑ I am not the sharpest pencil in the box You could try switching the passenger relay with the driverside.
dang, i don't want to spend too much money on this van since it's a piece of junk but it's my only mode of transportation. or some of the other windows stop working for some period and then going back to operating. HI, I am trying to download this and I keep getting an error. Create an account Forum Stay Dirty Lounge Service and Repair Questions Answered Here 2003 Windstar Drivers Side Window not working TOPIC: 2003 Windstar Drivers Side Window not working Tweet 2003 Windstar
motor directly from battery but that did not work. Pretty obvious it's either in the fuel pump or security/electrical. c_ferrucci Ford F-150 0 11-04-2005 11:44 PM Tags 03, drivers, fix, ford, motor, rear, side, van, window, windows, windstar, winstar, wont, work, working « Previous Thread | Next Thread » Thread Stephen Lutz 5,034 views 11:06 2000 windstar power window motor - Duration: 6:07.
Intermittently drips coolant from 11/11/2016 11/11/2016 tsmodie I'm looking for the fuse location in my 1998 ford expedition 11/11/2016 11/11/2016 muddyford Where is the bcm on 2014 ford explorer located on, When I hit the button all I here is a clicking noise. It worked fine today when I got it in, then of course the sun went down.... Mike Carr 140,020 views 9:38 Loading more suggestions...
Push those points down so they don't work through the tubing. Do all the other windows work? on your vehicle, it is not possible to directly access the driver's window motor directly from the switch. I really hope this is the problem or else we are stuck again.