Either the back or the butt/back together. I was guessing it could maybe be a fuse problem? Getting the leather off and back on is the toughest part, and hardest work. This new service calibration was released with TIS satellite data update version 6.5 available June 13, 2005. Check This Out
If the ignition key is cycled OFF and back ON again, the heated seat will operate correctly. It's too cold to figure out if the cooled seats are working so I cannot check if they are working.Thanks in advance, I think my wife is ready to have her GM-Trucks.com @ SEMA 2016 -Video Walk Through of Chevy Booth -Silverado Carhartt Concept -Silverado Alaskan Concept -Colorado Race Support Concept -Chevy launches new Crate Engine Lineup -Silverado High Desert Concept -Trax Also checked in the side (interior) fuse box--manual seems to have dozens of fuses--but not the one I need.
Since you have replaced all these parts already, and i assume the modules programmed with the latest software, then i think this bulletin may help... The light on the switch will stay on for about 6 seconds and then shut off. Page 1 of 2 1 2 Next > Feb 24, 2010 at 12:10 PM #1 jdpromo33 Proud Tahoe Owner Posts: 690 Likes Received: 0 Joined: Dec 18, 2009 Location: Bloomfield, New
There will be DTCs B2435, B2440, B3606 and/or B1825 set in the Drivers Seat Module. Did you get any clues as to what is causing this to happen? I assumed it was just a bad heater element as it was a problem I had with the heated seat in my 2001 durango a year ago. 2005 Gmc Sierra Heated Seat Problems Total Queries: 13 Zlib Compression is on.
This occurs only with the first activation for the day and works correctly with subsequent activations immediately after the event. Fuse For Heated Seats Chevy Silverado Where as the heated seat thermistor circuit must be working correctly before EITHER heated seat will operate. just went through this this past week.How much were the replacement elements gradywhite Feb 20 2010, 09:15 PM long story short.....took it to dealer in december. http://z71tahoe-suburban.com/iboard/lofiversion/index.php?t25935.html Watch Queue Queue __count__/__total__ Find out whyClose 2004 Silverado Heated Seat Problem biggtdp SubscribeSubscribedUnsubscribe3232 Loading...
They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. 2005 Silverado Heated Seat Fuse Skip navigation UploadSign inSearch Loading... The adjustable pedal position sensor, seat recliner position sensor and both heat seat thermistors share the same 5 volt reference internal to the Drivers Seat Module. An open in either heated seat thermistor circuits (signal or low reference).
Seat Heat Sensor- Normal range 1V-4VDrvr. I plugged it back up last night to see if it mysteriously solved itself, but no. 2004 Chevy Silverado Heated Seat Problem EIGHTIES NUT 43,627 views 9:24 How to replace the Heating seats module - Duration: 8:49. Silverado Heated Seats Turn On By Themselves RobDog Apr 1 2011, 11:38 AM Seat heater does the exact same thing.
All times are (GMT -0800) Pacific. http://camtronics.net/heated-seat/2003-yukon-xl-heated-seats-not-working.html The lights come on, but the warmers never do. A fault in any of these components/circuits can make the heated seats inoperative or shut off in 30 seconds, as well as, the seat recliner and/or adjustment pedals may move in The "right way" is probably to take the seat apart or at least to fully remove the leather from the cushion in order to get it perfectly flat in the back 2003 Chevy Silverado Heated Seat Problems
But as an update to my problem I have noticed that the problem only seems to occur when I turn on the whole seat heat on the drivers side. I may try if my back is bad and let you know if no one else knows for sure.(Later edit) Nevermind, I have realized the error of my thought here. The drives bottom is burned bad. this contact form From what i understand, to access the element you have to pull back the seat covering.
Shop around. Chevy Avalanche Heated Seat Problem Code B2425. driver side heated switch will stay on for only a couple seconds on any of the 3 heat settings. 1998 ECSB Chevy Z71, DUALS, K&N, 6" RCD, AAL, Atlas 16x8, 315's
D/S normally wears faster than P/S. So from what I'm gathering, the elements in the driver's side are bad and "all I have to do" is remove the leather and it will be obvious what the problem I have a 2009 Suburban for my wife and both the driver and passenger seat warmers stopped working a few weeks ago. Tahoe Heated Seat Repair had the same problemin my 2003...
biggtdp 59,440 views 2:52 How to replace the Heating seats module - Duration: 8:49. Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... The switch goes on- lights up but then goes out. navigate here If so how hard is it to replace? -RyanMyTruck:2003 Silverado Z71, 5.3L, ls1 Fans w/ white1 harness, Remote Starter, SS LT headers, Magnaflow catback, FLT Lv4 trans, TT3000, tuned by me
No joy and it keeps my bottom side HOT all the time. Could this just be a short in the heating element and that needs replaced or in the wiring? but the drivers bottom light comes on for maybe a minute then goes off. The adjustable pedal position sensor, seat recliner position sensor and both heat seat thermistors share the same 5 volt reference internal to the Drivers Seat Module.
Cscottsss Feb 5 2013, 08:30 AM QUOTE (carguru @ Feb 5 2013, 08:40 AM) Most likely the heating grid in the seat cushion is dead.Thanks for the quick response. Then I thought better and figured that if it was a blown fuse, the lights on the switch would not be working either. the leather had cracked and the service manager warrantied it out for me since i was already out of warranty. Took me a while to completely figure out the method to the madness, but the driver side didn't take near as long.Both seats had burned elements on the BACK heater pad.