Will calling GMC make any difference? Make sure flange on adapter is clean and all oil is out of inside of adapter 3. Yes No Voted Undo Score 0 Cancel Comments: what engine and what type of tranny do you have? 10/19/2011 by oldturkey03 Add a comment 0/1024 Cancel Post comment Are you sure I had the rattling in the column after about a year of owning it, SO I took it back to the dealer and they said that it was the stablizer bar Check This Out
the issue is cold solder joints on the front of the circuit board. The cluster has been replaced, the speed sensor has been replaced and even some wiring has been replace. Go to an auto parts store and buy either a Haynes manual, or a Chiltons manual for the Yukon. I am very far from being a mechanic. http://www.topix.com/forum/autos/chevrolet-tahoe/T7IEVBBFPJQIQHNVG/p2
Mark helpful 0 Report Jackhammer54 answered about a month ago also sometimes if I go back and forth several time on the ignition but not turn it over it will reset Any help with that would be great.We talked to our chevy dealership this morning and they told us that there were no recalls for anything. Mark helpful Your Answer Add photo Photo (optional) Related Questions 1994 GMC 4l60e transmission shifting problems 25 answers I've got a 1994 GMC Sierra 4X4 5.7 I purchased from an older Sign in to add this video to a playlist.
FTBrs2 Enthusiast | Posts: 653 | Joined: 09/06 Posted: 02/07/07 08:21 PM Not really normal, but it would be something wrong with the Electrical... Not good!!Recall? Mark helpful 190 Report Mark answered about a year ago ignition switch damn autocorrect 4 out of 4 people think this is helpful. 2004 Chevy Silverado Speedometer Cluster One flywheel.
Mark helpful 240 Report Jeffrey answered 2 years ago its more then likely the seo ign 10 amp fuse in the fusebox next to driver door the fuse looses power causing by DrSpeedometer in repair Download 9 Steps Share Favorite I Made it! issue 11 out of 11 people think this is helpful. Only a couple of days ago so not tested good.
Thanks for your comment! 2003 Gmc Yukon Instrument Cluster Problems But, like I said, I am far from being an experienced mechanic, and can only hypothesize. If we can explore any available options with you, please send us an email with more information, including your name/Edmunds username, contact information (phone and address please), the last 8 of Thanks!!!
I have never done that before, but the procedure should be the same, you would mark where the current needle sits at when off with some tape or something, remove and
The speedometer is a pain and annoying because so many people have had this problem with the same vehicle.. http://www.instructables.com/id/DIY-Finally-How-To-Repair-a-GM-Instrument-Cluster-/ Ensure all sensors and new seals are in replacement unit, if used unit...finding correct seal for front shaft is pain so keep your old one so you can check O.D. 2004 Chevy Tahoe Instrument Cluster Fuse Search under "country1998a".http://www.youtube.com/watch?v=2u51-HTpweI 0 · Share on Facebook golfman34 Posts: 1 May 2009 My 2004 Denali speedometer works or does not, and sometimes displays the wrong speed. 2005 Chevy Silverado Speedometer Not Working If you accidently go too far simply keep rotating counter clockwise until you get back ...Show All ItemsDo you drive a GM car (200 and up) and have gone past 70-80
Loading... his comment is here On Sale Now 4 Answers Filter by: Most Helpful Newest Oldest Chosen Solution mayer @mayer Rep: 429.4k MacHale Enterprises 757 474 1.5k Posted: 11/01/2011 Options Permalink History To avoid being accused We use the new OEM factory redesigned motors (X25.168), not old surplus or motors stripped from junkyard units that will fail again. Notify me when there are new discussions. 2004 Gmc Sierra Instrument Cluster Dead
Took less than an hour, works great, and only cost $52.00 w/ shipping. It should be visible from the lower corner of the windshield. Was this answer helpful? this contact form Only major engine repair was a flywheel for the starter.
Anyone else experienced this after replacing the cluster? 2004 Chevy Silverado Instrument Cluster Not Working Starting with headlight bulbs burning out about every month, gps not able to read disc or not turning on, rear door cargo glass constantly breaking at the hinges, radio only works Mark helpful 100 Report EdMullis answered 3 weeks ago For what it might be worth, the first thing I'd try is to look for a short somewhere in the speedometer circuit,
Start truck. QUESTION :I haven't seen any answer about recall. may save you some bucks It does work which is why I posted in the first place....granted you may have to do it once a week or once a month but 2003 Gmc Sierra Instrument Cluster Not Working The dealership will perform a "sweep" test where they will use the computer and command the needles to sweep.
Instead they told me the one place in town that was cheap enough to do work for them, North Wells Auto Service in Fort Wayne, Indiana. Cancel Dusko Rep: 1 Posted: 10/31/2011 Options Permalink History It is probably your Vehicle speed sensor. Also when it is really hot in the summer it does not work. navigate here I've posted to another newsgroup and received an interesting reply that GM does know about the problem, which is in the stepper motor, and with a bit of argument, I might
The truck has 51,000 mostly highway miles on it. They sent out a servey about this truck and I ripped it up, it was so they can make the next truck better. Today, I went to the dealer and also called GM. I like my regular dealer, but I'm not sure who is right.
Mark helpful 110 Report Raymond answered 2 years ago My 2000 Tahoe LT 4×4 has that not changing gears issue. The speedometer is at 35 mph when sitting still and the odometer is working right. What's my best option?