Home > Key Fob > 2000 Audi A4 Key Fob Not Working

2000 Audi A4 Key Fob Not Working

Contents

I even tried to reset the key as it says in my audi book. Turned the audi off and remove the master key and all worked well. Anyone actually tried a way to do this that has worked ? I only needed to do 2-4, but maybe in your case, having two keys (with one inserted into the ignition in the accessory position) is critical? Source

It's still under warranty until next June before the CPO kicks in. Good luck! I was then able to push the switch with my thumb, fooling the car into thinking that I was using a key on the outside.Full process:To program new remotes on a you took out the old battery & put in a new one.

Audi Key Fob Not Working After Battery Change

Perform the synchronization between each remote control key and the vehicle: 2000-2008 A4 Open the vehicle mechanically with the key. Rating is available when the video has been rented. Wait 10 seconds.

Wait about 1 min and open car put one of keys in ignition and turn it to on.(Take it the fob from remote from key in ignition). Otherwise skip to step 16.*** 13. Lock or unlock the vehicle once mechanically with the key. Reprogram Audi Key After Battery Change Chad Boughton 28,174 views 5:18 Audi Light Switch Removal ~ 1998 A4 A6 A8 S4 VW - Duration: 6:19.

About Press Copyright Creators Advertise Developers +YouTube Terms Privacy Policy & Safety Send feedback Try something new! Audi A6 Key Not Recognized Turn key to off, remove from ignition and release button. I need the key to use to get a remote car starter installed- will the key have all the same functions as the original key based on your programming instructions? weblink The doors should unlock.

Press the unlock button three times with a one second interval in between, the lights will flash with each button press for a total of three flashes. 12. Audi Key Fob Flashing Red Light I'd recommend to get a quote from locksmith for how much cutting the key alone is, how much for the chip programming, and how much for both. Good luck! I also learned that the physical key would be enough to lock and alarm the car, and to unlock and drive, this is good to know since most of our newer

Audi A6 Key Not Recognized

The only way I was able to get it programed was I had to install the Master Key in the ignition and turn it to on.

turned the key to lock the door. Audi Key Fob Not Working After Battery Change It has OFF, ON, START. Audi A3 Key Fob Not Working Key will only open drivers door, then all doors open once ignition is on.

The doors should unlock. this contact form Take a key (valet key works best, put it into the ignition and turn the key to the "on" position, so the dashboard lights come on.2. THIS IS NOT PERSONAL! Reply With Quote 08-11-200912:49 AM #19 clumpymold View Profile View Forum Posts View Blog Entries Visit Homepage View Articles Veteran Member Three Rings Join Date Feb 12 2004 AZ Member Audi A4 Key Fob Doesn't Work

The doors should unlock. Take a key (valet key works best, put it into the ignition and turn the key to the "on" position, so the dashboard lights come on. 2. Last edited by road race s4; 01-21-2010 at 07:41 AM. have a peek here Thanks for the info Reply Comment by Paulo October 23, 2012 at 8:57 pm Hi, I only had one key and I lost it.

This should do the trick. Audi Tt Key Fob Not Working Follow test plan J393-central control module for comfort system, adapting remote control key via adaptation (channel 21). After that get out of your car and with second key close your car (not with remote) and press 5x unlock button on your remote.

TrendyFlickz 1,677,924 views 7:21 How to program/code Audi, VW, Seat key/ Kako kodirati-programirati kljuc za Audi,VW,,Seat - Duration: 1:05.

In the interest of brevity, the following instructions are limited to programming four key fobs. The doors should unlock. thanks dude i didnt know this either Gcc's blacksheep Reply With Quote 08-10-200910:52 AM #8 joeycuccaro View Profile View Forum Posts View Blog Entries Visit Homepage View Articles Account Terminated Reprogram Audi Tt Key Fob It totally worked and I am still using it to this day as my primary key.

Here is the combo that worked for me: Car is already unlocked... I urge all users to read the site's privacy policy which you can find HERE This will show how the site uses these cookies along with other privacy related items. The internet needs more awesome people like you! Check This Out It's possible that the locksmiths you are calling are replying "no, I can't cut a key" is because they don't have the key blank on hand?

To start viewing posts, select the forum section that you want to visit from the selection below. TIA B6 S4 | MT6 | F.I. In this case, a valet key is a good option. I'm open for any other suggestions.

pressed the lock button on the key fob once 4. Wait 10 seconds and press the unlock button. When I bought my car CPO, they sent me a brand new key fob. So I spent over an hour searching various Audi forums about how to duplicate the key and program the remote key fob.

Reply Comment by Felix Wong August 20, 2014 at 10:06 pm I have no idea, Mike. Here is how you do it... Rating is available when the video has been rented. Rick Mammana 337,696 views 4:43 Key Fob Not Working - Solution! | Sherwood Park Toyota - Duration: 2:22.

Thanks...and I did check both and they were working previously. I don't know about your cars but my s4 doesn't have an ACC position. Tried it on both of the keys I have and it didn't work :( Held it for 5-10 seconds, and even tapped it a few times as well. The lights will flash once. 6.

That first transmitter is now programmed. Try it and please report if it works or not. EliteAutoOutlet10 270,613 views 5:06 AUDI KEY PROGRAMMING PROGRAMMER A4 A5 Q5 - Duration: 3:02.